USB Type-C and USB-PD
 • Supports USB PD 3.0 including Programmable
    Power Supply(PPS)
 • Support type C connection handshaking
 • Built-in Rp & BMC Physical Layer
 • Integrated VCONN power and switch for
    reading E-marked cable(75mw)
 • Provider(source) only

VBUS
 • VBUS Short circuit detected
 • Embedded charge pump and slew rate control
    for NMOS VBUS switch
 • PMOS VBUS switch
 • VBUS quick discharge
 • VBUS Monitor

Support kinds of USB interface for power charge
 • Stand downstream port(SDP)
 • BC1.2--Charge downstream port(CDP)
 • BC1.2--Dedicated Charge port(DCP)
 • Fast charger Protocol
    (FCP,18W,5V~9V STEP 0.5V)
 • Smart charger Protocol
    (SCP,22W,5V/4.5A,4.5V/ 5A)
 • QC2.0(5V,9V,12V,20V)
 • QC3.0(5V,9V,12V,20V, Continuous mode)

Fault protections
 • VBUS Short circuit detected
 • Over temperature protection (>140℃) 

PD CC1/CC2 status change

MCU
 • 8051 compatible MCU
 • 8K bytes One-Time-Programmable OTP
 • 8K bytes VIA ROM
 • PD Protocol, Policy Engine and Device
    Policy Manager
 • Fast Charger Protocol (FCP)
 • Smart Charge Protocol (SCP)
 • 256 bytes SRAMX2
 • Deep sleep mode
 • Deep sleep Wakeup source:
 • VBUS short detected
 • PD CC1/CC2 attach
 • PD CC1/CC2 detach

External PARALLEL FLASH interface for Test Chip
 • DP_A/DM_A status change
 • GPIO change
 • Over temperature

PD CC1/CC2 status change

Internal RC oscillator 12MHZ ,10KHZ

Internal LDO 5V,1.8V,3.3V

Serial interface:I2C,UART,SPI

Package: 8-Pin SOP,16-Pin SSOP,64-PIN LQFP(Test Chip)

Operating voltage range: 5V~20V

Operating temperature:-25℃ to +125℃